Myhixel Control II, 1 unit

Abs with rubber coating

1. Open the box and remove your MYHIXEL II device.
2. Before using it for the first time, it must be fully charged. Only use the supplied charging cable. Connect it to the device as explained in the pictures and plug it into the mains using a 5V adapter for 3-4 hours (you can use the same charger as your mobile phone with the cable supplied). If it is not the first time you use it, before charging it, make sure that the device is completely dry, paying special attention to the area of the magnetic charging pins.
3. Once charged, disconnect it from the mains, and press button 2 for at least two seconds. After this time, the two buttons will light up, confirming that the device is switched on.
4. How to connect the app to your device:
IMPORTANT: you will not be able to connect your device to the app via Bluetooth until you have activated your MYHIXEL PLAY. Go to the URL of your MYHIXEL PLAY activation card to see the complete tutorial.
4.1 To connect the app to the device via Bluetooth, press buttons 1 and 2 at the same time (2 seconds) until they start flashing simultaneously.
4.2 Open the MYHIXEL Play app and from the main screen, press "Connect Device". Follow the instructions until the connection is complete.
5. To start the device warming up, press button 1. The LED on the device will light up and start flashing indicating that the device is warming up. After 3 minutes, the LED will stop flashing, indicating that the correct temperature has been reached. However, unless you remove the heating base or press button 1 again, the device will continue to heat up for a further 5 minutes (a total of 10 minutes), reaching a higher temperature. After these 10 minutes, it will automatically stop heating. Therefore, if you want to interrupt the heating process before the 10 minutes are up, simply press button 1 again or open the heating base.
6. Once heated and connected to the App, remove the heating base to gain access to the sleeve. To remove and replace the heating base, always do so directly and vertically, without turning it. Also make sure that the lid fits correctly and that the magnetic pins make a connection when closing.
7. We recommend using lubricant with your device. Lubricate the inlet hole and the inner channel of the sleeve liberally. Use a water-based lubricant, such as MYHIXEL Lube.
8. IMPORTANT! Before using the device, make sure that the two suction tabs (see "MYHIXEL II Device" section) are open so that you can insert your penis easily and without feeling discomfort from the suction effect.
9. The device is now ready for use. Insert your penis when it is erect. Once you have inserted it, adjust the suction level to your liking according to the intensity of suction you prefer, closing one or both of the suction tabs that will allow air to escape. Tip: if you have difficulty opening the side tabs with your fingernail, use a sharp object or something similar.
10. Press button 1 so that the device starts to vibrate (the App will tell you when to turn the vibration on and when not to). Press it again to turn off the vibration. Note that the same button is used to heat and vibrate the device. Whether it heats up or vibrates depends respectively on whether the cover is on or off, i.e. it heats up with the cover on and vibrates with the cover off.
11. If during penetration you have the feeling that the friction is excessive, apply a little more lubricant, as this should be distributed throughout the channel of the sleeve.
12. Relax and enjoy doing the activities guided by your programme from the MYHIXEL Play app.
13. Once you have finished, clean your MYHIXEL II device as described in the section "Cleaning and storing the device".